L. Wang ,
 Konica Minolta Laboratory USA, Inc., San Mateo, CA, USA
Organic light emitting diode (OLED) is an emerging technology for next-generation flat panel display and solid-state area lighting thanks to its many advantages such as light weight, low operating voltage, and flexibility, etc. A typical OLED has a multilayer structure that includes a glass or plastic substrate, an anode (ITO), a hole transport layer (HTL), an emitting layer (EML), an electron ...
G. Latha, P. Nair
SSN College of Engineering, Chennai, Tamil Nadu, India
In a solid core PCF, structural parameters and the number of rings in the cladding region decide confinement losses, dispersion coefficients as well as bending losses. This paper evaluates some of commercially available solid core photonic crystal fibers. The dispersion coefficients and sensitivity of these fibers are estimated using COMSOL Multiphysics®, and compared with the theoretical values ...
Prof. Dr.-Ing. habil. A. K. Palit ,
 ZF-Lemfoerder Electronic GmbH, ZF-Friedrichshafen AG. Group, Espelkamp, Germany
Introduction: RFID system uses a Transponder and the near field communication (NFC) antenna and a matching circuit (Figure-1) in which at least latter two must be optimally designed for a higher efficiency. Typically, RFID antennas are flat inductive coils with 2 to 4 turns and are printed directly on the PCB. The larger antenna size implies larger operating distance whereas, the number of ...
O. E. Hin 
 Monash University, Malaysia
In this study, a computational model is developed and solved using COMSOL Multiphysics software to estimate the lesion size during saline-infused RFA. Transport of saline is set up by modifying the Poisson equation and the convection-diffusion equation  under the Mathematics module. Heating during RFA is set up based on the Joule heating module. To describe the lesion size, the two-state cell ...
J. Grover, Dr. A. Gupta
Birla Institute of Technology and Science, Pilani-Pilani Campus,Rajasthan ,India
In high-speed digital design, strong electromagnetic coupling exists between adjacent transmission lines. This manifests itself in the form of crosstalk voltage induced on either line. Crosstalk is modeled in terms of capacitance and inductance matrices which are extracted using COMSOL Multiphysics®. Further, trends of crosstalk are observed with variations in dielectric constant of substrate, ...
C. T. Nadovich ,
 Lafayette College, Easton, PA, USA
The use of grating couplers to couple conventionally phased and polarized light near vertically in and out of optical slab or film waveguides  represents an attractive method to interface optical fiber to photonic ICs. Previously developed grating coupler designs use transversely uniform grating structures matched to conventional scalar fiber modes. The performance of these geometries can be ...
H. Arab, F. Afshar, C. Akyel
École Polytechnique de Montréal, Montréal, QC, Canada
Department of Electrical and Computer Engineering, McGill University, Montréal, QC, Canada
In this project a two dimensional second order nodal and linear edge elements programming model for homogeneous waveguide is developed and simulated in MATLAB® software Environment. The objective is to reduce or eliminate spurious solutions and to cater for any arbitrarily shaped waveguides using triangular edge elements. The formulation is developed using the E-Field and to make use of the ...
A. Leggieri, F. Di Paolo, D. Passi
Univeristy of Rome "Tor Vergata" - Department of Electronic Engineering, Rome, Italy
This paper describes the design and characterization of an 8 slots resonant cavity Magnetron, which undergoes thermal-structural effects due to cathode heating. The proposed study involves Thermal Stress, Eigen-frequency and Particle Tracing analysis based on COMSOL Multiphysics®. Magnetrons are well known and often utilized High Power Radiofrequency Vacuum Tube oscillators. In order to ...
M. Mattheakis, C. Athanasopoulos, G. P. Tsironis
University of Crete, Heraklion, Greece
We present numerical simulations for the propagation of surface plasmon polaritons in a dielectric-metal-dielectric waveguide using COMSOL Multiphysics® software. We show that the use of an active dielectric with gain that compensates metal absorption losses enhances substantially plasmon propagation. Furthermore, the introduction of the active material induces, for a specific gain value, a ...
G. Bachelier , L. Olgeirsson , S. Waterman , J. Sharma , E. Dujardin , A. Bouhelier , S. Huant 
 Institut Néel, CNRS - Joseph Fourier University, Grenoble, France
 Imperial College, London, England
 CEMES, CNRS, Toulouse, France
 LICB, CNRS – Bourgogne University, Dijon, France
The unique optical properties of plasmon resonances in noble metal nanoparticles have been extensively investigated owing to their ability to enhance the electric field amplitude but also to tailor its spectral and spatial distribution. Among all application domains, nonlinear optics play a singular role since the efficiency of the underlying physical processes are driven by specific symmetry ...