Community > Discussion Forum > Meshing 3D geometry

Discussion Forum

Meshing 3D geometry

Topics: Mesh, 4.2a

Thread index  |  Previous thread  |  Next thread  |  Start a new discussion

RSS FeedRSS feed   |   Email notificationsTurn on email notifications   |   0 Replies   Last post: February 5, 2012 8:53pm UTC
Cindy Duong

Cindy Duong

February 5, 2012 8:53pm UTC

Meshing 3D geometry

Hello,

I am trying to figure out the correct way to mesh a 3D geometry that consisted of a chamber containing several cells as shown in the attached figure. When I applied the free tetrahedral mesh to the entire geometry I was able to model the diffusion of my analyte of interest but my domain point probe plot do not show the concentration vs. time for the two points I have set as 60 um above the bottom of the chamber (hence on the same level as the cells). This makes me think that meshing is just a surface mesh and not a volume mesh as evident by a very low mesh volume in the statistic menu.

Any help is much appreciated,
CDuong

Attachments:   cells in chamber.png  

Reply  |  Reply with Quote  |  Send private message  |  Report Abuse


Rules and guidelines